Artesyn MVME55006E Single Board Computer Installation and Use (July 2014) - Manual (Page 42)

Hardware Preparation and Installation
MVME55006E Single Board Computer Installation and Use (6806800A37J) 42
1.9.3 Secondary PMCspan
The PMCspanx6E-010 PCI expansion module mounts on top of a PMCspanx6E-002. To install a
PMCspanx6E-010, perform the following steps while referring to the figure on the next page:
Procedure
This procedure assumes that you have read the user’s manual that was furnished with the
PMCspan, and that you have installed the selected PMC modules on your PMCspan according
to the instructions provided in the PMCspan and PMC manuals.
1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to an
electrical ground. Note that the system chassis may not be grounded if it is
unplugged. The ESD strap must be secured to your wrist and to ground throughout
the procedure.
2. Perform an operating system shutdown. Turn the AC or DC power off and remove
the AC cord or DC power lines from the system. Remove chassis or system cover(s)
as necessary for access to the VME module
3. If the Primary PMC Carrier Module and MVME5500 assembly is already installed in
the VME chassis, carefully remove it as shown in Figure 1-18 and place it with
connectors P1 and P2 facing you.
Personal Injury or Death
Dangerous voltages, capable of causing death, are present in this equipment.
Use extreme caution when handling, testing and adjusting.
Product Damage
Inserting or removing modules with power applied may result in damage to module
components.
Avoid touching areas of integrated circuitry, static discharge can damage these circuits.