Artesyn MVME55006E Single Board Computer Installation and Use (July 2014) - Manual (Page 36)

Hardware Preparation and Installation
MVME55006E Single Board Computer Installation and Use (6806800A37J) 36
5. With standoffs installed in the four mounting holes on the RAM5500 module, align
the standoffs and the P1 connector on the module with the four holes and the P4
connector on the MVME5500 host board and press the two connectors together
until they are firmly seated in place.
6. Turn the entire assembly over and fasten the four short Phillips screws to the
standoffs of the RAM5500.
7. Reinstall the MVME5500 assembly in its proper card slot following the procedure in
the next section. Be sure the host board is well seated in the backplane connectors.
Do not damage or bend connector pins.
8. Replace the chassis or system cover(s), reconnect the system to the AC or DC power
source and turn the equipment power on.
4237 0903