Thread in the label ribbon at the dispensing edge, Als 380 – Avery Dennison ALS 380 User Manual
Page 27
25
3
P
RIOR
TO
OPERATING
3.1 I
NSERT
THE
LABELLING
MATERIAL
ALS
380
Thread in the label ribbon at the dispens-
ing edge.
➔
Swing up the pressure roller [17D] behind the dis-
pensing edge.
➔
Unthread approximately 2 m of label ribbon from the
label roll.
➔
Guide the label ribbon around the first deflection
roller [17A] and through the slot in the photoelectric
sensor [17B] for the dispensing edge.
➔
Guide the label ribbon around the dispensing edge
to the drive roller unit [17C].
➔
Thread the label ribbon around the drive roller unit
and the second deflection roller [17E].
➔
Swing the pressure roller back into operating posi-
tion.
[17] Guides for the label ribbon at the dispensing edge
A 1st Deflection roller
B Label stop sensor
C Drive roller unit
D Pressure roller (shown here in operating position)
E 2nd Deflection roller
D
A
B
C
E