Avery Dennison ALS 380 - Manual (Page 80)

78
6 O
PERATIONAL MALFUNCTIONS
6.2 E
RROR MESSAGES
ALS
380
6.2.1 If a malfunction occurs
If the control system detects a serious error:
– The labelling operation is stopped.
– An error code is displayed on the operator panel. If the cause of the error has been eliminated:
➔ Acknowledge the error message by pressing the
ENTER key.
6.2.2 Error codes
Message Description Possible causes and remedies
E__1 The loop space is not filled. Label roll empty:
➔ Replace label roll.
Pressure roller not closed:
➔ Swing up the pressure roller on the drive roller unit’s un-
wind unit and return it to its position pressing against the
roller. The pressure roller clicks neatly into its operating
position.
Unwind unit drive defective:
– Repair by servicing technician is required; refer to
Service Guide
The photoelectric sensor in the loop
space does not actuate. Reflective surface is dirty:
➔ Clean the reflective surface.
Use of very bright labels or
Sensor potentiometer out of adjustment or
Sensor defective:
– Adjustment/replacement by servicing technician is
required; refer to Service Guide
6.2
ERROR MESSAGES