Avery Dennison ALS 380 - Manual (Page 77)

75
5 A
FTER OPERATION
5.1 C
ARE AND CLEANING
ALS
380
Capacitive sensor at the dispenser head
Only if the labeller is equipped with a capacitive
sensor [76A] instead of the proper photoelectric sen-
sor:
➔ Remove the knurled thumb screw [76B].
➔ Remove 2 screws on the underside [77A].
➔ Remove the upper part of the housing [78A].
➔ Clean the sensor surfaces [78 arrows] with soft,
lint-free rags.
➔ Reassemble the sensor.
➔ Test the sensor adjustment.
[76] A Capacitive sensor
B Knurled thumb screw
[77] A Fastening screws for the housing on the underside
[78] A Upper part of the housing with sensor surfaces (arrows)
A
B
A
A