Avery Dennison ALS 380 - Manual (Page 79)

77
6 O
PERATIONAL MALFUNCTIONS
6.1 W
ARNING MESSAGES
ALS
380
W__2 Memory errors
Factory settings are activated, see
appendix. CPU battery is discharged after a long shut-down period of
the machine:
➔ Leave the machine switched on for some time to re-
charge the battery
If the accumulatorerror occurs frequently:
➔ Have the CPU battery replaced by the responsible
servicing technician.
Settings no longer available after software update.
Settings must be input again by a servicing techni-
cian; refer to Service Guide.
W__3 Too many labels between label stop
sensor and dispensing edge. Label stop sensor must be adjusted by servicing
technician; refer to Service Guide.
W__4 Dispensing speed is too high.
This negatively affects position accu-
racy. ➔ Reduce dispensing speed (VELO), if the warning-
message is frequently displayed for long periods.
For automatic dispensing speed (APSF):
A check of the EGRA function by servicing techni-
cians is required; refer to the Service Guide
W__5 The roll diameter control (optional)
reports the end of the label roll. ➔ Insert new labelling material.
W__6 Data transmission error at the
V24 interface The cables, plug connections, and interface param-
eters must be checked by servicing technicians; re-
fer to Service Guide
W__7 Label position on the product too
close to the product’s leading edge
and high dispensing speed ➔ Increase the setting value for POS, decrease dispensing
speed (VELO).
If this is not possible or the warning message
reappears:
The settings in the configuration menu must be
checked by servicing technicians; refer to Service
Guide.
Message Description Possible causes and remedies