Datalogic Scanning MAGELLAN 8500 - Manual (Page 194)

6-88 Magellan ® 8500 Scanner
RS-232 Beep After Weigh
Enables/disables the ability of the scanner to beep after weight data is
transmitted to the host. Scale interfaces that support this item are: RS-232
ICL, RS-232 SASI, and RS-232 Single Cable.
To enable/disable the Beep After Weigh feature:
1. Scan the SWITCH bar code.
2. Scan either the enable or disable bar code below. You’ll need to
cover any unused bar codes on this and the facing page to ensure
that the scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
BEEP AFTER WEIGH = DISABLE
BEEP AFTER WEIGH = ENABLE