Datalogic Scanning MAGELLAN 8500 - Manual (Page 75)

Product Reference Guide 3-13
4. Fully seat the new vertical scan window into the window channel
within its bottom retention tabs. Tilt the window in to engage the
two tabs at the top of the retainer and carefully snap the window
to secure it in place.
5. Clean both sides of the new vertical scan window using a paper
towel or lint free cleaning tissues dampened with a mild, water-
based glass cleaner. DO NOT use abrasive cleaners or pads.
6. Re-install the platter. Vertical scan window replacement is now
complete.
Horizontal Scan Window Replacement (WRG)
Wear Resistant Glass (WRG) horizontal scan windows are replaceable and
can be removed and replaced following the instructions below.
1. Remove the All Weighs™ Platter from the scanner as shown in
Figure 3-3.
2. Turn the platter upside down on a clean, dry surface and remove
the four screws shown in Figure 3-5. Retain all screws for later re-
installation.
3. Once the vertical bezel is freed from the platter, the WRG win-
dow can be slid from its channel as shown. Carefully dispose of
any damaged glass.
4. Slide a new WRG window fully into the channel.
5. Re-install the vertical bezel using the original four screws.
6. Clean both sides of the new WRG window using a paper towel or
lint free cleaning tissues dampened with a mild, water-based glass
cleaner. DO NOT use abrasive cleaners or pads.
7. Re-install the platter. WRG window replacement is now com-
plete.
NOTE
Sapphire glass does not require replacement, so it is permanently fastened
in place. Do not attempt to remove Sapphire glass from the platter.