Flowcharts, Flowcharts -7, Product reference guide – Datalogic Scanning MAGELLAN 8500 User Manual

Page 83

Advertising
background image

Product Reference Guide

4-7

Flowcharts

The problem isolation flowcharts on the following pages allow you to
identify and troubleshoot problems with your system.

Figure 4-2. Problem Isolation: Start

START

YES

NO

Does

the scanner

power-up

?

YES

NO

Does

the scanner

pass Selftest

?

YES

NO

Is the

Green LED

Lit

?

YES

NO

Is the

Green LED

Lit

?

YES

NO

NO

Will the

scanner read

bar codes

reliably

?

YES

NO

Have you

checked the

power

connections

?

Check these
potential problems:
- AC power cord
- AC/DC adaptor
- AC outlet

Power-up

Scanner power-up is signified by any or

all of the following:

- Facet wheel shows movement

- Lasers turn on

- Status LED(s) turn on

- Speaker sounds tone(s)

- Remote display shows message

- A single red dot is visible on the 7-

segment display

Selftest Failure

If the scanner fails its Selftest, the

following takes place:

- Speaker sounds a tone at the lowest

value for approx. 3 seconds.

- Green and Yellow LEDs flash on and

off alternately.

- 7-segment display shows a code (1 to

C) to indicate the failure.

Consult the Selftest flowchart if you're

unsure the unit has passed Selftest.

Flashing Green LED

If the Green LED is flashing slowly, the

scanner is most likely in Sleep Mode.

Press and release the Volume/Tone

Push Button or wave your hand in front

of the vertical window to "wake-up" the

scanner.

A flashing Green LED can also mean

the scanner has been disabled by the

POS terminal. To exit this mode, cycle

power or have the terminal re-enable

the scanner.

For units using an AC/DC adapter, verify that...

1. AC power cord is connected to a functional AC outlet.

2. IEC connectors are firmly connected.

3. DC power cord is firmly connected to scanner.

If your unit is a model which receives Power Off the

Terminal POT), verify that the I/F cable is securely

connected at both ends.

Magellan

Power

Supply

Go to Selftest
flowchart

Go to Poor/No
Reading flowchart

YES

Does the

scale weigh

correctly

?

Go to Scale
flowchart

Ensure the Green LED is
enabled via pro-
gramming bar codes.

Call Tech Support

Other Problems?

Call Tech Support

Advertising