Becker revo.2 - Manual (Page 24)

24
>>> GENERAL OPERATION
> D
> GB
> F
> I
> PL
Adjusting the unit holder’s position
> Loosen the fastening screws a
until the carrier plate can be moved
without using excessive force.
> Move the carrier plate to the
required position and hold it in this
position.
> Tighten the fastening screws and
sufficiently so that the Navigation
device is held securely in place when
the vehicle is in motion.
Mounting the navigation device
> Hang the display on the upper hook of
the mounting bracket
> Move the display downwards, it will
then be mounted by the magnetic
mounting bracket
Removing navigation device
> Remove the display carefully down
from the mounting bracket
> Move the display approx. 45° upwards,
and lift it slightly.
Switching the Navigation device
on/off (model dependent)
With the ON/OFF switch (I/O) you can
switch the Navigation device on or off
completely.
With the
button on the upper side of
the Navigation device you can switch the
device to sleep mode or switch it from
sleep mode again.
For devices without the button on the
underside (model dependent): With the
button you can switch the device off,
on or to the sleep mode.
4
6
6
4
5
Note:
The device is woken from the sleep
mode once the display is mounted.
Note:
The device will go into sleep mode when
the display is removed in the switched-
on state.
1
2
1
2
1
2