Becker revo.2 - Manual (Page 26)

26
>>> GENERAL OPERATION
> D
> GB
> F
> I
> PL
For devices without the I/O switch on the
underside:
> Press the switch on the top of the
navigation device for longer than
3
seconds to finally switch it off.
Basic information about the
touch screen
The Navigation device is fitted with a
touch screen.
Operation
When you touch a button on the touch
screen, the button in question is briefly
shown outlined in red to confirm the
selection.
If you touch a button that is not active at
the moment, a short signal tone sounds.
Capacitive Display (depending on the
model)
If your device has a capacitive display,
you can perform even more actions in
addition to the normal touch screen ope-
ration.
> By moving a button upwards and
downwards in a list the list can be mo-
ved.
> The map section on the map can be
increased or decreased in size using
two fingers. If you touch the display
with two fingers and then move your
fingers closer together, the map is
reduced in size.
If you touch the display with two fingers
and move your fingers further apart, the
map is increased in size.
> By moving two fingers on the display
to the left, you will return to the
previous entry level as with the
button.
Note:
We recommend that you place the
Navigation device in sleep mode in the
event of short interruptions to operation
(of up to a week).
This significantly reduces the switch-on
time and the Navigation device finds the
satellites required for navigation much
faster.
If route guidance was active when sleep
mode is activated, it is automatically
resumed if the Navigation device is
switched back on again within approx.
4 hours.
If the device cannot be switched off
anymore or no longer works reliably, it
is possible to switch off devices without
I/O switches completely by pressing the
button on the top for longer than
7 seconds.
Note:
To ensure that the display's surface is
not damaged, you may only touch it with
your fingers or a blunt, non-smearing
object.