Becker revo.2 - Manual (Page 32)

32
>>> GENERAL OPERATION
> D
> GB
> F
> I
> PL
Radio remote control
You can control most functions and the
main functions of the Navigation device
using the remote control. The remote
control operates using radio frequency
(maximum range 5 metres) and
therefore does not need to be installed in
sight of the Navigation device.
Attaching the remote control
> Take a coin and insert it into the slot in
the base plate of the remote control.
> Turn the coin anti-clockwise.
This unlocks the base plate, which can
now be removed.
> Insert the supplied battery (CR2032/
DL2032) into the battery compartment
with the positive side facing up.
> Press down the battery until it locks
into place.
> Select a suitable position to install the
remote control.
> Position the base plate so that the
word UP is pointing in the direction of
travel.
> Secure the base plate using the
supplied screws or self-adhesive film.
Note:
It is not absolutely essential for the
function of the Navigation device to
install the remote control.
Note:
Attach the remote control so that it does
not impair your ability to operate your
vehicle. The remote control must not be
attached within the deployment area of
the airbag or on an airbag cover.
Centre console
Armrest
Note:
If you wish to stick the base plate in
place, you will first need to clean the
adhesive surfaces.