Datalogic Scanning 9500 - Manual (Page 29)

Product Reference Guide
2-1
Chapter 2
Site Preparation and
Installation
This chapter provides a reference for preparing most checkstands to
receive the scanner or scanner/scale. Included are physical parameters and
instructions for checkstand preparation, power and ventilation consider-
ations, cable routing information and unit installation.
Site Preparation lists all procedures necessary to prepare the checkstand.
The instructions that follow, titled
Checkstand Preparation , detail steps for
the three models that are available (shown in Figure 2-1 below) to facili-
tate easy installation into almost any checkstand application around the
world:
Some models are designed to fit with little or no modification into open-
ings cut for previously installed scanners such as Magellan
® scanners, or
NCR ® scanner models 7820/24 and 7870. Other models are designed for
applications with smaller footprint requirements.
Once the procedures in this chapter are complete, the scanner is ready for
scanning operation
1
; with the exception that if a scanner/scale was
installed, calibration will be required before placing the unit into opera-
tion. You must consult the local weights and measures authority to ensure
that all legal requirements are met concerning calibration and certifica-
tion.
Chapter 5 , Calibration , contains detailed procedures for calibrating
the scale in either pounds or kilograms.
Model 9501 — Scanner only Model 9502 — Scanner/Scale
1. Electronic Article Surveillance (EAS) operation requires the installation of the Sensormatic ® Scan-
Max Pro TM antenna and controller.