Datalogic Scanning 9500 - Manual (Page 343)

Interleaved 2 of 5 (I 2 of 5) Enable
Product Reference Guide
6-227
I 2 of 5 Length Control
This feature specifies whether variable-length or fixed-length decoding
will be set for I 2 of 5.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan your selection from the bar codes below. You’ll need to cover
any unused bar codes on this and the facing page to ensure that the
scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
I 2 OF 5 LENGTH CONTROL = VARIABLE-LENGTH
I 2 OF 5 LENGTH CONTROL = FIXED-LENGTH
NOTE
If variable-length control was selected, you must now set the features I 2 of 5
Maximum Label Length and I 2 of 5 Minimum Label Length. If fixed-length
control was selected, you must now set
I 2 of 5 Fixed Length 1 and I 2 of 5
Fixed Length 2.