Datalogic Scanning 9500 - Manual (Page 406)

A-10
Magellan ® 9500
Calibration Switch
This switch initiates the scale’s calibration routine. A certified weight set is
needed to perform the scale calibration steps detailed in
Chapter 5 , Cali-
bration . This switch is not included in scanners without scale modules.
Calibration Switch Seal
This seal allows you to secure the Calibration Switch access cover and
restrict access to the Calibration Switch. If the calibration seal is broken or
missing, you may be prohibited from operating the scale without recertifi-
cation. Check local and state requirements for specific restrictions.
Calibration Switch Cover
This cover restricts access to the Calibration Switch to help guard against
unauthorized tampering when sealed. See
Figure A-1 .
Figure A-1. Calibration Switch Cover
LEGAL NOTE
There are regulations that must be followed in order to ensure
compliance when operating a weighing device such as the scan-
ner/scale. Failure to observe and comply with these regulations
could result in legal action.
LEGAL NOTE
Calibration Cover
Calibration Switch