Compuprint 6314 - Manual (Page 52)

Compuprint 6314/6414 - User Manual
3.5.8 Backfeed Speed Selection
This function sets the backfeed speed.
Press Enter function key to enter in the BACKFEED SPEED sub-menu:
- nn: scroll through the numerals with the Scroll function key, and then confirm with the Enter
function key up to the last cursor position, when the menu item appears. The backfeed speed is
indicated in inches per second (ips). The value range is between 2 and 10 in steps of 0.5 ips
(Depending on the model that you have).
3.5.9 Print Head Heat Selection
This function selects the temperature of the print head that directly affects print quality. The optimal
temperature depends on the type of ribbon and support used.
Press Enter function key to enter in the PRINTHEAD HEAT sub-menu:
- nn: the temperature can be adjusted with this parameter and with the Hnn software commands (a
description of which is found in the Programmer Manual of the current emulation). Scroll
through the numerals with the Scroll function key, and then confirm with the Enter function key
up to the last cursor position, when the menu item appears. The value range is between 01 and 20
(the default value is 12).
3.5.10 Cut Cycle Selection
This function sets the label cut cycle. When the cutter is installed and enabled, all labels, or each
group of n labels, can be cut.
Press Enter function key to enter in the CUT CYCLE sub-menu:
- nnnn: scroll through the numerals with the Scroll function key, and then confirm with the Enter
function key up to the last cursor position, when the menu item appears.
3.5.11 Paper Rewinder Torque
This function selects the label rewinder torque. The printed labels (or the silicon support when the
tear bar assembly/peel-off system is used) are rewound with a torque constant commanded motor to
guarantee uniform tension.
Press Enter function key to enter in the PAPER REW TORQUE sub-menu:
- nn: scroll through the numerals with the Scroll function key, and then confirm with the Enter
function key up to the last cursor position, when the menu item appears. The value range is
between 4 and 13.
3.5.12 Ribbon Rewinder Torque
This function selects the ribbon rewinder torque. The used ribbon is rewound with a torque constant
commanded motor to guarantee uniform tension.
Press Enter function key to enter in the RIBBON REW TORQ. sub-menu:
- nn: scroll through the numerals with the Scroll function key, and then confirm with the Enter
function key up to the last cursor position, when the menu item appears. The value range is
between 4 and 13.
52