Column offset, Select final character, Control codes – Compuprint 6314 User Manual
Page 56: 5 column offset, 6 select final character, 7 control codes
Compuprint 6314/6414 - User Manual
3.6.5 Column Offset
This function sets the value of the column offset. It is possible to move the printout image respect to
physical edges of the label through the column offset. By this item (which can be overwritten via
software) you can move all the fields in the label right with respect to the left lower corner edge of
the form.
Press Enter function key to enter in the COLUMN OFFSET sub-menu:
- nnnn i (m): select the unit of measurement between i (the values are indicated in hundredths of
an inch) and m (the values are indicated in tenths of a millimeter) using the Scroll function key.
After having chosen the unit of measurement, use the Enter function key to move to the number
you want to modify, scroll through the numerals with the Scroll function key, and then confirm
with the Enter function key up to the last cursor position, when the menu item appears.
3.6.6 Select Final Character
This function (FINAL CHARACTER) sets the command terminator. Press Enter function key to
enter in the SET FINAL CHAR sub-menu The default value is OD (hex) - carriage return.
Scroll through the numerals with the Scroll function key, and then confirm with the Enter function
key.
The value range is between 0D (hex) and FD (hex)
3.6.7 Control Codes
This function (CONTROL CODES) selects the control characters to be used before the commands.
Press Enter function key to enter in the CONTROL CODES sub-menu. Press Scroll function key to
scroll through the various items of this function:
- STANDARD CODES*: the control characters are those set by factory (SOH and STX).
- ALTERNATE CODES: the control characters sent are ^ (5EH) and ~ (7EH).
56