Comtech EF Data DD240XR Rev Е - Manual (Page 41)

DD240XR High-Speed Digital Demodulator User Interfaces
MN-DD240XR – Rev. E 4-21
MODEM IP ADDR: {XXX.XXX.XXX.XXX}
The IP Address of the modem. This address should be
consistent for the mask defined. This address is
expressed in decimal format. For example:
For the decimal Modem IP Octets:
172.18.100.212
Mask: 255.255.000.000
Modem IP Address: AC.12.64.D4
Broadcast and loop back addresses will not be allowed.
These are addresses with all subnet bits set to 0’s or 1’s.
SERVER IP ADDR: {XXX.XXX.XXX.XXX}
The IP Address of the Boot Server and the address of
the SNMP Trap Server when SNMP is active. If a server
is used and there is no local router, this address must be
consistent with the modem address. If a router has been
specified, the address is presumed to be reachable via
the router. For example:
For the modem 172.18.100.212
No router, and server: 172.18.28.253
Mask: 255.255.000.000
Modem: 172.18.100.212
Router: 171.000.000.1
Server: 172.18.40.15
For the modem 172.18.100.212
Router on the same network: 172.18.1.5 and
server on a different network: 196.24.14.250
Mask: 255.255.000.000
Modem: 172.18.100.212
Router: 172.18.1.5
Server: 196.24.14.250
Broadcast and loop back addresses will not be allowed.
These are addresses with all subnet bits set to 0’s or 1’s.
ROUTER IP ADDR: {XXX.XXX.XXX.XXX}
The IP Address of the Local Network Router. If a router
is present on the local network, this address must be
consistent with the IP Mask and the subnet of the
modem. If no router is present, then the address should
be set to a foreign address. This address is expressed
in decimal format. For example:
For the modem 172.18.100.212
No router, and server: 172.18.1.5
Mask: 255.255.000.000
Modem: 172.18.100.212
Router: 172.12.1.5
For the modem 172.18.100.212