Comtech EF Data HPOD - Manual (Page 135)

HPOD C-, X-, Ku-Band High-Power Outdoor Amplifier MN/HPOD.IOM
Appendix B Revision 8
B–5
The Web Server Interface features four (4) navigation tabs at the top of each page. Nested
hyperlinks (shown in gray) grant access to individual Web pages. The hyperlink for the
Redundancy page is available under the Config tab.
Home Access Amplifier Monitor
Contact SNMP Utility Alarms
Support
Redundancy
FETs
Click the Config tab, and then select the Redundancy hyperlink to continue.
B.2.2 Config | Redundancy Page
Use this page to configure the HPOD 1:1 or 1:2 redundancy operations settings.
Figure B-2. SSPA Web Server Interface – ‘Config | Redundancy’ Page
At any time, click [Refresh] to update this page and see the most recent data.
Redundancy State and Mode
• Use the drop-down list to set the Redundancy State as Off, 1:1, or 1:2.
• Use the drop-down list to set the Redundancy Mode as Manual or Automatic.