Comtech EF Data HPOD User Manual
Page 64
![background image](/files/778917/content/doc064.png)
HPOD C, X-, or Ku-Band High-Power Outdoor Amplifier
MN/HPOD.IOM
Ethernet-based Remote Product Management
Revision 8
4–16
•
Amplifier – Use the drop-down list to set the amplifier as On or Off.
•
Mute – Use the drop-down list to set the Mute function as Enabled or Disabled.
Click [Change Configuration] to save these settings, or click [Reset] to revert to the previously
assigned Amplifier settings.
Fault Recovery
Use the drop-down list to set Fault Recovery as Automatic or Manual, and then click [Change].
BUC Mute
Use the drop-down list to set BUC Mute as Muted or Not Muted, and then click [Change].
Reference Adjust
Enter a numeric value from 0 to 255 to set the reference oscillator tuning voltage. The default
voltage value is 87. Click [Change] when done.
Serial
• Remote Address – Enter a physical remote address from 0001 to 9999.
• Baud Rate – Use the drop-down list to set the operating baud rate as 9600 or 19200 bps.
Click [Change Serial Configuration] to save these settings.