Digi CM - Manual (Page 127)

Configuration Menu
Chapter 16 127
You can access this menu through a Telnet or SSH session using the IP
address of the Digi CM followed by the port number 7000 as in the following
example:
telnet 192.168.100.200 7000
By default root is connected to the command line interface and the preceding
option allows the root user access to the port access menu.
System Logging
System logging is a two part process. First, the device being used to record
the system logs must be configured. Secondly, system logging must be
configured for the system under System status and log. System logs can be
saved to the Digi CM system memory (there is no need to configure the
memory), a compact-flash card, an NFS server, or a SYSLOG server.
Configure the System Log Device
To configure the compact-flash card for system logging, see "Adding a
Compact-flash Card" on page 27. Adding a Compact-flash Card For an NFS or
SYSLOG server, do the following:
1. Access the configuration menu.
2. Choose Network configuration > NFS or SYSLOG server configuration.
3. Disable or enable the server.
4. Use the ESC key when all parameters are entered to return to the main menu.
5. Choose Save changes.
Configure System Logging
1. Access the configuration menu.
2. Choose System Status & log > System logging.
3. Enter the desired parameters for the menu items.
4. Use the ESC key when all parameters are entered to return to the main
menu.