Digi CM - Manual (Page 58)

Config Alerts for Automatic Device Recognition (ADR)
58 Chapter 5
Config Alerts for Automatic Device Recognition (ADR)
Before configuring the alerts for Automatic Device Recognition, be sure you
have configured the port for ADR as described in "Configuring Automatic
Device Recognition" on page 42.
1. Access the web interface.
2. Under the Serial Port heading, Click Configuration.
3. Choose All or an Individual port > Alert Configuration .
4. Follow the Email Alert steps to configure the email alert or follow the SMTP
Notification to configure SMTP.
5. Complete configuration and choose Save & apply .
Email Alert SMTP Notification
Enable "Email Alert for active
detection"
Enter the Title of email
Enter Name and email address
where the email should be sent.
Enable "Active detection trap"
Configure the trap receiver by one of the
following two ways:
Enter "Use global SNMP configuration"
OR
Enter the IP address of the trap receiver,
the SNMP trap community and select the
version