Digi CM - Manual (Page 130)

Sniff Sessions
130 Chapter 16
4. Choose a menu item and enter the desired parameters for the menu items.
5. Use the ESC key when all parameters are entered to return to the main
menu.
6. Choose Save changes.
Sniff Sessions
To configure a port or all ports for sniff users, do the following:
1. Access the configuration menu.
2. Choose Serial port configuration.
3. Choose an individual port number or 0 (zero) for all ports > User access
control.
4. Choose User Access Control.
5. Choose Enable/Disable Sniff Mode.
6. Choose a menu item and enter the desired parameters.
7. Use the ESC key when all parameters are entered to return to the main
menu.
8. Choose Save changes.
For information on entering a sniff session, see the next section, "Viewing A
Sniff Session" on page 131.