Digi CM - Manual (Page 73)

Custom and Default Menus
Chapter 8 73
There are multiple ways to access the PortAccess menu:
•
Assigned IP address (see "Configuring Host Mode" on page 47)
• TCP/IP port 7000
• TCP/IP port 22 or 23 if the “Shell program” is set to “port access menu” for
this specific user (see chapter "Administering Users" on page 59)
• By calling “portaccessmenu” from the command line
The PortAccess menu allows simple access to each port.
By typing the number of the port to connect to, the Digi CM initiates a
connection to this port using the appropriate protocol (Telnet of SSH).
You can also change your own password by using the “P” Key.
If the Digi CM is configured to be the master in a master-slave scenario, the
“S” key will bring up a list of all slaves. Selecting a slave will then spawn a
connection to the Port Access Menu of the slave.
When using a Digi CM 48 not all ports can be displayed on one screen. Ports
33-48 can be viewed after hitting the <Enter> key.