Configuring system logging – Digi CM User Manual
Page 36
Configuring System Logging
36
Chapter 5
Enable Digi CM Memory
The Digi CM memory is already enabled for port logging and only needs to be
configured for system or port logging. When storing log files to the Digi CM
local memory, a total of 3.5M is available. The amount of memory per serial
port is dependent on the port count of the Digi CM used. The log file sizes are
shown in the following table are maximum settings. See also Configuring
System Logging on page 36.
Configuring System Logging
To configure the Digi CM for system logging, do the following:
1. Access the web interface.
2. Under System status & log, click System logging.
3. Choose Enabled for System logging and the log buffer size.
4. From the System log storage location, choose the location you want from
the drop down menu. The choices available are dependent on what you
have enabled and/or installed. The Digi CM memory choice is always
available.
System logging
- Enable or Disable
System log storage location
- Memory or NFS server
System log to SYSLOG server
- Enable to store system logs to a SYSLOG
server
System log buffer size (KB, 300 max) -
Log buffer size in KB
Send system log by Email
- Enable or Disable
Number of log messages to send a mail (1-100)
- Number of messages
Digi CM
System Log
Port Log
(per port)
Total Memory Used
8
300K
400K
3.5M
16
200K
32
100K
48
66K