Digi CM - Manual (Page 97)

Power Controller
Chapter 12 97
6. Under Everyone uncheck the Access type and click Save to flash .
7. Enter the user that will have access and check the Access type.
Note: Port is access to the port. Monitor is access to sniff. Power is access to the power
management.
8. Click Save to flash . Repeat steps 7 and 8 for additional users.
9. Click Save & apply after all users have been entered.
Note: The screen above shows outlets 1 & 2 control power to the Sun Server configured
on port 1 of the Digi CM. Outlets 3 and 4 are not serial devices. Gilligan has been
designated the specific user to control outlet # 3.
Configuring to Restrict Specific Users
To restrict specific users, you must select access for << Everyone>> and add
the restricted user by deselecting his or her access.
1. Log in to the Digi CM (username root, password dbps)
2. Click Power Controller > Configuration > Outlets > Select the outlet # to
configure.
3. Select the port to configure to the outlet. If it is a non-serial device select
None.
4. Edit the outlet title. If there is a serial port, the port title will appear and
cannot be edited from this screen.
5. Click Save & apply.
6. Check Everyone and click Save to flash.
7. Enter the username that will NOT have access, uncheck the Access types
that are restricted, and click Add.