Fluke Biomedical RF303 - Manual (Page 27)

Installation, Setup, and Maintenance
Installation and Setup
2
2-3
Installation and Setup
The Analyzer has a universal power supply and automatically operates with
applied main voltages having a maximum range of 83-264 V ac. You do not
need to adjust voltage via jumpers or programming tabs to operate the
Analyzer.
Set up the Analyzer for operation by attaching the supplied power cord to the
power cord inlet located on the right panel of the Analyzer case. If necessary,
please refer to “Instrument Familiarity” to help you identify the power cord
inlet.
Power-Up Sequence
After plugging the Analyzer into a correctly rated earth-ground outlet, locate
the power switch on the right panel. Move the switch to the ON position
(marked with the
– symbol). Next, you should observe the following power-up
sequence:
1. The three front LED indicator lamps illuminate, and you see this
information momentarily appear in the display:
exz01.eps
2. Next the installed version of the Analyzer’s firmware briefly appears in
the display. Here’s an example: