GAI-Tronics L3149B C200 Advanced Deskset - Manual (Page 23)

L3149B (C200) Advanced Tone Remote Desk Set Operation
17
Paging
These desk sets support the following formats:
 DTMF  1500
 Immediate DTMF  2805
 2-Tone  Custom 2-Tone
 5-Tone
Paging may be initiated by entering digits on the numeric keypad, by programming an alias using the
XAC0008A C200 Programming Software, by configuring any of the programmable buttons, or by PC
control. The alias feature allows user-determined names to be assigned to specific paging capcodes. This
permits selecting a frequently-used paging sequence by name rather than by re-entering digits on the
keypad.
Entering the Paging Menu
Make sure the desk set is in normal operation. Press the
PAGE
button. The normal status line appears at
the top of the LCD display. The second line displays the paging type and spaces to indicate the number of
capcode digits that must be entered.
Selecting the Page Type
The available page types are set by the programming software. Use the
SELECT
button to cycle forward
or
LOCK
+
SELECT
to cycle backward through the enabled types.
Entering Capcode Digits for Paging
If the desired capcode is not currently selected, a new capcode may be entered:
Use the numeric keypad buttons to enter the paging capcode digits. Enter the digits A, B, C or D by
pressing
LOCK
+
1
,
LOCK
+
2
,
LOCK
+
3
, and
LOCK
+
4
. Enter the digits E and F by using the * button
and # button, or by using
LOCK + 5
and
LOCK + 6
.
The LCD displays the capcode as it is entered from right to left. As new digits are entered, the previous
digits are moved one position to the left and the new digit is entered in the right-most location. If another
digit is entered after all the blanks are filled, the capcode will be cleared and the user must start over.
Pressing the
CLEAR
button clears the capcode. All blanks must be filled or the transmission cannot be
initiated.
N
OTE : The maximum number of digits that can be entered can be programmed using the XAC0008A
C200 Programming Software.