GAI-Tronics L3149B C200 Advanced Deskset - Manual (Page 60)

Programming L3149B (C200) Advanced Tone Remote Desk Set
54
Manual Paging
Page PTT Frequency
If the system is configured such that pages should be transmitted on a particular channel, the page PTT
frequency may be used. This parameter allows the selection of the page PTT frequency for all manual
pages. In addition the desk set can be configured to remain on the page PTT frequency until manually
changed by the operator.
Keep Page PTT Frequency after Page
If a page PTT frequency is used, the unit will normally revert to the previous function tone after a page is
complete and the talk time has expired. This may not be desirable if the operator wishes to remain on the
page channel to further transmit to the paged party. In this case, setting this parameter causes the unit to
stay on the page channel until the operator manually changes the channel back.
N OTE : This parameter is available only if Page PTT Frequency is not Disabled.
Paging PTT Pretime
This parameter sets the length of time after the beginning of the transmission before the paging tones are
transmitted. For tone control, this time begins at the end of the function tone. The valid range is 0 ms to
2000 ms
in 10 ms increments.
N OTE : This parameter affects alias paging as well.
6 dB/Octave De-emphasis Enable
This parameter enables/disables 6 dB/octave de-emphasis. If this parameter is enabled, all paging is
de-emphasized 6 dB/octave before being put on wire lines. This is helpful when paging tones are going
to be in the 300 Hz to 500 Hz range. If this parameter is disabled, all paging is put on wire lines flat.
N OTE : This parameter affects alias paging as well. De-emphasis is not applied to DTMF paging.
DTMF Paging
Maximum Digits Allowed from Keyboard
This parameter controls the maximum number of digits that may be entered by the operator. The valid
range is 0 to 6.
DTMF Interdigit Time
This parameter controls the duration of the DTMF digit and pause between digits (digit time and pause
are always equal). The valid range is 50 ms to 550 ms in 50 ms increments.
N OTE : This parameter affects alias paging as well.
DTMF Paging Preamble
Allows you to preset up to nine DTMF preamble digits for each channel. The valid range for each digit
is 0-9, A–F, # and *.
TALK NOW Timer for DTMF Paging
This parameter allows selection of the length of time a user is allowed to talk after the paging signal. If
the
TRANSMIT
button is pressed during TALK NOW time, the unit continues to transmit until the button
is released. The range is 0 to 45 seconds. If 0 seconds is selected, the operator is not allowed to talk
after the page.