Paging – GAI-Tronics L3149B C200 Advanced Deskset User Manual
Page 30
Operation
L3149B (C200) Advanced Tone Remote Desk Set
24
Example 2:
To send a call alert to MDC1200 alias 1 (i.e. FIRE 100) do the following. Note that the alias number is as
listed in the software under MDC1200 aliases.
PC to C200: ‘^’, <CR>
C200 to PC: ‘0’, ‘1’, ‘8’ (C200 Response)
PC to C200: ‘1’, ‘0’, ‘2’, ‘1’, ‘~’ (C200 does Call Alert)
C200 to PC: “O <DS ID> FIRE 100 HH:MM:SS MM:DD:YY CAL ALT”
C200 to PC: “I FIRE 100 <DS ID> HH:MM:SS MM:DD:YY ACK CAL ALT”
C200 to PC: ‘~’ (Acknowledgment to PC that Call Alert is complete)
Paging
Paging allows the PC to direct the C200 to transmit a paging sequence using a preprogrammed alias or a
specified cap code. The behavior of each specific page type is controlled by software programmed
parameters.
Byte Value
Description
0 2
‘2’ (0x32): Always for Paging
1
0 or 1
‘0’ (0x30): Indicates an alias number is used
‘1’ (0x31): Indicates a capcode is used
2
Page Type ‘1’ (0x31):
DTMF
‘2’ (0x32):
2-Tone
‘3’ (0x33):
Plectron
‘4’ (0x34):
5/6 Tone
‘5’ (0x35):
2805
‘6’ (0x36):
1500
Y1
First ASCII digit of capcode or alias number (Most significant digit)
4
Y2
Second ASCII digit of capcode or alias number
5
Y3
Third ASCII digit of capcode or alias number
6
Y4
Fourth ASCII digit of capcode
7
Y5
Fifth ASCII digit of capcode
8
Y6
Sixth ASCII digit of capcode (Least significant digit)
9 X
Don’t
Care/Unused
Example:
To send a 2-Tone page using capcode 123 and the software programmed settings for 2-Tone paging:
PC to C200:
‘^’, <CR>
C200 to PC:
‘0’, ‘1’, ‘8’ (C200 Response)
PC to C200:
‘2’, ‘1’, ‘2’, ‘1’, ‘2’, ‘3’, ‘~’ (Page transmitted)
C200 to PC:
‘~’ (Acknowledgment to PC that page is complete)