GAI-Tronics L3149B C200 Advanced Deskset - Manual (Page 49)

43
Programming
PC Programming
General Description
C200 Programming Software (included on No. XAC4000A Programming Bundle CD) is needed to
program the features of your equipment. It allows entry of programming data into your PC for transfer to
your equipment. The programmed data can be retrieved and edited, and printed in hard copy form for
recordkeeping.
Hardware/Software Requirements
This software is for use on PCs with Windows 95 or higher operating system (not compatible with
Vista). The computer should have 8 Mb of memory, VGA or higher, with one serial port. Use 800
 600
or higher resolution to optimize viewing.
Communication Port
Data is transferred via a serial communications port on the computer. The port must be RS-232
compatible, and either COM1, 2, 3 or 4 port on the computer can be used.
Connections
The L3149B must be connected to your PC with the 25-pin D-connector cable (Part No. XAC0004A)
before the programming software can be used. Connect the cable to the COM 1, 2, 3 or 4 connector on
the computer. Connect the other end to the programming jack on the PL1877A.
Installing the Programming Software
Start the Windows program and ensure that all other applications are closed.
 Insert the XAC4000A Programming Bundle CD (will auto-run).
 On the initial set-up screen, select C200 Programming Software and click on Install.
 Follow the system prompts to install.
Proper installation will create an appropriate icon on the PC’s desktop.