GAI-Tronics L3149B C200 Advanced Deskset - Manual (Page 59)

L3149B (C200) Advanced Tone Remote Desk Set Programming
53
Monitor
When the Type of Interface is Local control, a monitor closure is necessary to place the radio in to
monitor mode. This monitor relay is configured as a normally open momentary relay and is asserted
when the
MONITOR
button is pressed and disasserted when the
MONITOR
button is not pressed. Note
that the relay also contains a normally closed contact.
PTT
When the Type of Interface is Local control, a PTT closure is necessary to place the radio in to
transmit mode. This PTT relay is configured as a normally open momentary relay and is asserted when
the
TRANSMIT
button is pressed and disasserted when the
TRANSMIT
button is not pressed. Note that
the relay also contains a normally closed contact.
Relays Asserted
Assign which relays are asserted when the relay's state changes.
N OTE : This is assignable only when a relay output is set to something other than Disabled. Also,
multiple relays can be assigned to one operation as well as multiple operations being assigned to a single
relay. In the latter configuration, the relay is affected by the last operation only.
Configure Paging
This feature allows the selection of paging types available to you in the paging menu. You may also
determine the order in which the selected paging types appear. Paging types enabled here have no effect
on which paging types are available in any part of the software. All paging types will be available.
To Enable a Paging Type
Highlight the paging type's name under Available Paging Types. More than one may be selected.
Click on the Add button. The name(s) move to the Paging Types in Use area. The new entry or
entries are placed at the end of the list.
To Disable a Paging Type
Highlight the paging type's name under Paging Types in Use. More than one may be selected. Click
on the Remove button. The name(s) move to the Available Paging Types area.
To Change the Order of Selected Paging Types
Highlight only one paging type under Paging Types in Use. Click on Move Up to place it higher on
the list. Click on Move Down to move it lower in the list. Click on an area of the window for a
description of its function.