Gasboy FuelOmat system 8 Popt Commverter - Manual (Page 121)

NOTE
Only your laptop and the CommVerter should be
connected to the switch hub
 Obtain and write down on a separate paper all the relevant communication
parameters of the CommVerter:
o MAC address,
o IP address,
o Serial ports parameters,
o TCP port configuration and so on.
NOTE
After the upload procedure [from versions 0.58 or 0.69 to
any other higher version] all parameters in commVerter
are being erased and should be set again.
 Connect the laptop to the switch hub
 Connect the CommVerter to the switch hub a
 Try to ping the CommVerter from your laptop ( in order to validate the Comm. link
 In the laptop, create a directory and enter the following files:
o “bsp8p_controler.bin”
o “tfd32.exe”
 Disconnect the CommVerter from the switch hub
The next procedure consists of running the tfdp32.exe application.
8 Port CommVerter Operation and Installation Manual 117