Gasboy FuelOmat system 8 Popt Commverter - Manual (Page 70)

Figure 2-47 Terminal Block and 3-Wire Pulser – Wiring Connections
2.13.3. Pulse Divider
The Pulse Divider P/N 800911300 (see Figure 2-48) is used in cases where the pulser output cannot
be read by the MPI-C due to weak signal, too high frequency or differential signal.
The Pulse Divider receives the inappropriate pulser signal (Pickup signal), shapes it and/or divides
its frequency to match the signal to the MPI-C requirements for reading.
The Pulse Divider can be connected in three ways: refer to Table 2-6 and Table 2-7 for optional
connections and pinout.
Figure 2-48. Pulse Divider
8 Port CommVerter Operation and Installation Manual 66