Marantz SR7008 - Manual (Page 174)

174
Appendix Tips Playback Connections Contents
Front panel Display Rear panel Index Remote
Settings
2 Video Output
Selects which HDMI outputs to use.
Auto(Dual) (Default) : The presence of a TV connected to the HDMI
MONITOR 1 or HDMI MONITOR 2 connector is
detected automatically, and that TV connection
is used.
Monitor 1 : A TV connected to the HDMI MONITOR 1 connector is
always used.
Monitor 2 : A TV connected to the HDMI MONITOR 2 connector is
always used.
%
• If both the HDMI MONITOR 1 and HDMI MONITOR 2 connectors are
connected and “Resolution” (vpage 176) is set to “Auto”, the signals are
output with a resolution compatible with both TV.
• With “Resolution” (vpage 176) not set to “Auto”, check whether the
TV you are using is compatible with the resolution under “Video” – “HDMI
Monitor 1” or “HDMI Monitor 2” (vpage 207).
• This can be set by pressing HDMI OUT on the main unit.
2 HDMI Pass Through
Selects how the AV receiver will pass HDMI signals to the HDMI
output in standby power mode.
On (Default) :
Passes the selected HDMI input through the AV
receiver’s HDMI output when the AV receiver is in
standby power mode.
Off : No HDMI signals are passed through the AV receiver’s HDMI
output in standby power mode.
2 HDMI Control
You can link operations with devices connected to HDMI and
compatible with HDMI Control.
On : Use HDMI control function.
Off (Default) : Do not use HDMI control function.
%
• Please consult the operating instructions for each connected device to check
the settings.
• Refer to “HDMI control function” (vpage 132) for more information about
the HDMI control function.
NOTE
• If the “HDMI Control” settings have been changed, always reset the power
to connected devices after the change.