Marantz SR7008 - Manual (Page 200)

200
Appendix Tips Playback Connections Contents
Front panel Display Rear panel Index Remote
Settings
Settings
Make settings for wired LAN.
• If you are using a broadband router (DHCP function), there is no need
to make the settings at “IP Address” and “Proxy”, since the DHCP
function is set to “On” in this unit’s default settings.
• Only set “Settings” when connecting to a network without a DHCP
function.
DHCP
-IP Address
-Subnet Mask
Proxy
Save
Cancel
-Address
-Port
-Default Gateway
-Primary DNS
-Secondary DNS
Configure the network settings manually
Off
192.168.000.001
255.255.255.000
255.255.255.000
000.000.000.000
000.000.000.000
Off
000.000.000.000
00000
Network/Settings
2 DHCP
Selects how to connect to the network.
On (Default) : Configure the network settings automatically from your
router.
Off : Configure the network settings manually.
2 IP Address
Set the IP address within the ranges shown below.
• The Network Audio function cannot be used if other IP addresses
are set.
CLASS A: 10.0.0.1 – 10.255.255.254
CLASS B: 172.16.0.1 – 172.31.255.254
CLASS C: 192.168.0.1 – 192.168.255.254
2 Subnet Mask
When connecting an xDSL modem or connector adapter directly to this
unit, input the subnet mask indicated in the documentation supplied by
your provider. Normally input 255.255.255.0.
2 Default Gateway
When connected to a gateway (router), input its IP address.
2 Primary DNS, Secondary DNS
If there is only one DNS address indicated in the documentation
supplied by your provider, input it at “Primary DNS”. If two or more
DNS are provided by your provider, enter both “Primary DNS” and
“Secondary DNS”.