Marantz SR7008 - Manual (Page 190)

190
Appendix Tips Playback Connections Contents
Front panel Display Rear panel Index Remote
Settings
Error messages
An error message is displayed if Audyssey® Setup could not be completed due to speaker placement, the measurement environment, etc. If an error
message is displayed, check the relevant items and perform the necessary measures. Be sure to turn off the power before checking speaker connections.
Examples Error details Measures
Microphone or Speaker is
None
• Setup and measurement microphone is not
detected.
• Not all speakers could be detected.
• Connect the included Setup and measurement microphone to the
SETUP MIC jack of this unit.
• Check the speaker connections.
Ambient noise is too high or
level is too low
• There is too much noise in the room.
• Speaker or subwoofer sound is too low.
• Either turn off any device generating noise or move it away.
• Perform again when the surroundings are quieter.
• Check the speaker installation and the direction in which the
speakers are facing.
• Adjust the subwoofer’s volume.
Front R : None • The displayed speaker could not be
detected.
• Check the connections of the displayed speaker.
Front R : Phase • The displayed speaker is connected with
the polarity reversed.
• Check the polarity of the displayed speaker.
• For some speakers, this error message may be displayed even if
the speaker is properly connected. If you are sure the connection is
correct, use p to select “Skip Error”, then press ENTER.