Marantz SR7008 - Manual (Page 231)

231
Appendix Settings Playback Connections Contents
Front panel Display Rear panel Index Remote
Tips
2 Desired sound does not come out
Symptom Cause/Solution Page
The volume does not increase. • The maximum volume is set too low. Set the maximum volume using “Limit”on the menu.
• Appropriate volume correction processing is performed according to the input audio format
and settings, so the volume may not reach the upper limit.
167, 204
–
No sound comes out with the HDMI
connection.
• Check the connection of the HDMI connectors.
• When outputting HDMI audio from the speakers, set “HDMI Audio Out” on the menu to
“AVR”. To output from the TV, set “TV”.
• When using the HDMI control function, check that the audio output is set to the AV amplifier
on the TV.
40, 41, 44, 45,
46
173
132
No sound comes out of a specific
speaker.
• Check that the speaker cable is properly connected.
• Check that a selection other than “None” is set for the “Speaker Config.” setting in menu.
• Check the “Assign Mode” setting in the menu.
• When the sound mode is “STEREO” and “VIRTUAL”, audio is only output from the front
speakers and subwoofer.
32
193, 194
192
–
No sound is produced from
subwoofer.
• Check the subwoofer connections.
• Turn on the subwoofer’s power.
• Set “Speaker Config.” – “Subwoofer” on the menu to “2 spkrs” or “1 spkr”.
• When “Speaker Config.” – “Front” in the menu is set to “Large”, depending on the input
signal and the sound mode, no sound may be output from the subwoofer.
• When no subwoofer audio signal (LFE) is included in the input signals, no sound may be
output from the subwoofer.
• You can make the subwoofer always output sound by setting the subwoofer mode to
“LFE+Main”.
33
–
194
193
198
198