Marantz M-CR610 - Manual (Page 105)

105
Appendix Settings Playback Connections Contents
Front panel Rear panel Index Remote
Tips
2 Cannot connect by Wi-Fi
Symptom Cause/Solution Page
Cannot connect to the network. • The network name and password (WEP, etc.) settings are wrong. Configure the network
settings according to the setting details of this unit.
• Reduce the distance between the wireless LAN access point and this unit, remove any
obstructions and make sure the view to the access point is unobstructed before trying to
connect again. Also, install microwave ovens and other network access points as far away
as possible.
• Check the router power supply.
• This unit is compatible with IEEE 802.11b/g.
• Configure the access point channel settings away from channels that are being used by other
networks.
• This unit is not compatible with WEP (TSN).
90
–
–
–
–
–
Cannot connect to WPS. • Check that the WPS mode of the router is operating.
• Within 2 minutes, press and hold the Wi-Fi Connect button on the unit for three seconds.
• A router/settings that are compatible with WPS 2.0 standards are required. Set the encryption
time to “None”, “WPA-PSK (AES)” or “WPA2-PSK (AES)”.
• If the router encryption method is WEP/WPA-TKIP/WPA2-TKIP, you cannot connect by
using the Wi-Fi CONNECT button. In this case, use the “Auto-Scan” or “Manual” method
to connect.
–
–
88
89, 90
Cannot connect to the network using
iPhone/iPod touch/iPad
• Update the iPhone/iPod touch/iPad firmware to the latest version. –