Marantz M-CR610 - Manual (Page 25)

25
Appendix Tips Settings Playback Contents
Front panel Rear panel Index Remote
Connections
Wireless LAN
To WAN side
PC
Internet
Modem
Router with
access point
z This unit comes with a built-in
Wi-Fi antenna.
%
• With this unit, it is possible to use the DHCP and Auto IP functions to make the
network settings automatically.
• When using this unit with the broadband router’s DHCP function enabled, this unit
automatically performs the IP address setting and other settings.
When using this unit connected to a network with no DHCP function, make the
settings for the IP address, etc., at “Network” (vpage 87)).
• When using this unit, we recommend you use a router equipped with the following
functions:
• Built-in DHCP server
This function automatically assigns IP addresses on the LAN.
• Built-in 100BASE-TX switch
When connecting multiple devices, we recommend a switching hub with a speed
of 100 Mbps or greater.
• Use only a shielded STP or ScTP LAN cable which is easily available at electronics
stores (CAT-5 or greater recommended).
• The normal shielded-type LAN cable is recommended. If a flat-type cable or
unshielded-type cable is used, other devices could be affected by noise.
• When using a WPS (Wi-Fi Protected Setup) compatible router, easy wireless
connection is possible by pressing this unit’s Wi-Fi CONNECT button. (See the
separate “Quick Setup Guide”.)
NOTE
• The types of routers that can be used depend on the ISP. Contact your ISP or a
computer shop for details.
• This unit is not compatible with PPPoE. A PPPoE-compatible router is required if
you have a contract for a type of line set by PPPoE.
• Do not connect an NETWORK connector directly to the LAN port/ Ethernet
connector on your computer.