NavCom Sapphire Rev.J - Manual (Page 121)

Sapphire Technical Reference Manual Rev. J
121
1.69 FSFORMAT (ASCII)
SF-3050 Sapphire SF-3040
This command is used to format the internal SD flash and the USB thumb drive (with USB
HOST mode enabled).
Command: [FSFORMAT]{A:,B:,}{DEFAULT, FAT, FAT32}
Parameter Definition
A Keyword that selects the internal SD flash
B Keyword that selects the USB thumb drive
DEFAULT Optional keyword that formats drive A as default (receiver-selected) FAT
FAT Optional keyword that forces FAT12 or FAT16
FAT32 Optional keyword that forces FAT32

When no option is specified, this command queries the current FAT for the
specified drive. When both the drive and the option are unspecified, this command
queries the current FAT for both drives.
1.70 Use this command with the SF-3050 2G internal memory device for data
logging. To download recorded data, refer to the [UPTIME
This command is used to retrieve the total time the receiver has been running since boot up OR
since the last time the user rest the timer.
Command: [UPTIME] RESET
Parameter Definition
RESET
RESET will reset the start time to the current time, so that the user can use this as a
counter from a specific point in time.
If the RESET parameter is not specified, the command will return the total time the receiver
has been running or since the last time the time has been reset.
Examples:
[UPTIME]
[UPTIME]1 day, 20:56:19
[UPTIME]RESET
[OK] UPTIME
[UPTIME]
[UPTIME]00:00:02