NavCom Sapphire Rev.J User Manual

Page 153

Advertising

Sapphire Technical Reference Manual Rev. J

153

USBMODE]HOST command to change the USB from mass storage

mode. Use the [LOGFILE]A:,FORCESTART command to force file logging on
the SD flash. A CHKDSK.SD file is then created, so a forced start will not be
necessary the next time.

The SD flash can be formatted using the [FSFORMAT command. Then use
the [UPTIME

This command is used to retrieve the total time the receiver has been running since boot up OR
since the last time the user rest the timer.

RESET will reset the start time to the current time, so that the user can use this as a
counter from a specific point in time.

If the RESET parameter is not specified, the command will return the total time the receiver
has been running or since the last time the time has been reset.

Examples:

[UPTIME]

[UPTIME]1 day, 20:56:19

[UPTIME]RESET