NavCom Sapphire Rev.J - Manual (Page 221)

Sapphire Technical Reference Manual Rev. J
221
1.170 SETTIME (ASCII)
SF-3050 Sapphire SF-3040
This command is used to set the approximate time and date in the receiver.

If the receiver already has the accurate time and date from tracking a live GNSS
signal, then this command does not take effect.

This command is typically used in conjunction with the [SET POSITION] command
to aid the receiver with startup, and is particularly useful when operating with a
GPS simulator.

The date and time entered with this command is only used during receiver startup.
It is not stored in the unit. Issuing this command with date and time information
while navigating will result in an error message.
Command: [SETTIME] year, month, {day}, {hour}, {minute}, {second}, {offset hr}, {offset min}
Parameter Definition
year full calendar year (integer) (1901 to 2999)
month calendar month (integer) (1 to 12)
day calendar day (integer) (1 to 31)
hour hour portion of the time of the day (integer) (0 to 23)
minute minute portion of the time of the day (integer) (0 to 59)
second second portion of the time of the day (integer) (0 to 59)
offset hr difference between UTC and time zone of time entered, in hours (integer) (-13 to +13)
offset min difference between UTC and time zone of time entered, minute portion (integer) (0 to 59). If
the offset hours are negative, the minutes will be construed as negative. An additional
minus sign is not required.
Default: offset hr = 0; offset min = 0
Example: [SETTIME] 2006, 07, 13, 11, 30
Set the date and time to 2006/7/13, 11:30:00