NavCom SF-3050 Rev.A - Manual (Page 109)

SF-3050 User Guide – Rev A
5-107
The user has full control over the utilized message
types and their associated rates via either
StarUtil-3000 or a third party software/utility.
Factory Default Output Messages
 NCT
Messages
Table 23: Factory Default NCT Messages & Response
Output on Ports COM1 and USB1
s
Message Rate Description
ALM1B On Change Almanac
CHNLSTA
nnel
TUS1B On Time 1Hz
ASIC & StarFire Cha
Status
EPHEM1B On Change Ephemeris
MEAS1B
(see
ata
Note
t D
below)
On Time 1Hz Raw Measuremen
MSG
Serial
PRODUCTINFO On Time 600 Sec
Product Type, Digital
Number, and System
Revision Number
MSGVERSION On Time 600 Sec Identification Block
PVT1B On Time 1Hz PVT Solution
PANICA On Change Factory Use
Output on All Ports
Mes ription sage Rate Desc
OK (mnem
d”).
ssful onic) On Change
Ack (“Acknowledge
Ack indicates a succe
operation.
?? (mnem
ged”).
e in
d.
onic) On Change
Nak (“Not Acknowled
NAK indicates a failur
executing a comman
PANICA On Change Factory Use