NavCom SF-3050 Rev.A - Manual (Page 29)

SF-3050 User Guide – Rev A
1-27
23. Perform one of these steps:
• If the NAV firmware installed in the receiver is
the most current version, go to the Upload
Software Options section below.
• If the NAV firmware installed in the receiver is
not the most current version:
• Check the versions of the other firmware.
• Write down all the firmware that must be
updated.
• Go to the Upload Firmware section below.
Upload Firmware
The required PC Baud rate to upload
firmware via the supplied DB9S cable
(RS-232) on COM2 is 57600 (default). This
requirement does not apply to the supplied
USB 2.0 Device cable.

Typically, if any firmware needs to be
updated, it is NAV and PIOAPP.
24. Click Receiver Options in
the Detailed Views menu
on the left side of the GUI
(see Figure 11). The
Receiver Options tab
opens.
Figure 11: Receiver Options