NavCom SF-3050 Rev.A - Manual (Page 112)

SF-3050 User Guide – Rev A
5-110
 Base and Rover Navigation
NavCom’s StarUtil-3000 provide
Setup
s Base and Rover
ap bilities. Refer to the StarUtil-3000 User
etails. The guide is included on the
F-3050 Product Configuration USB Flash
also is available on the NavCom web site.
files
setup c a
Guide for d
supplied S
Drive, and
User o
The SF 0
commands
port assign
and output
storage of
nly
used user pr supplied USB
e
the
fact
E,
on n

e
sends profile “RTK” to the receiver. It replaces
Pr
-3 50 utilizes commands or groups of
, known as User Profiles, to set the various
ments/parameters, navigation parameters,
message lists. The SF-3050 provides for
up to 20 user profiles. A file with commo
ofiles is included on the
flash drive.
To save the current configuration settings of the
receiver for future use, the user creates and names a
profile. A controller solution, such as StarUtil-3000, is
used to activate a user profile by its name.
Th user may command the SF-3050 to reset all of
user-controlled configuration parameters to the
ory default values (see the section, Profile NON
ext page).
A new profile sent to the receiver replaces th
currently used profile, but it does not
necessarily replace all the current parameter
settings. The new profile replaces only those
parameter settings that it specifies.
For example:
The default navigation elevation mask is 7
°.
The user changes the elevation mask to 12
° in
a profile named “Test”. The user subsequently