NavCom SF-3050 Rev.A - Manual (Page 90)

SF-3050 User Guide – Rev A
3-88
indicate that the connection is established (see
Figure 5).
If an Ethernet connection is not
establishe

d, use StarUtil-3000 to verify
the IP address of the SF-3050. A
serial connection must be used to
determine the receiver’s IP address.
Event
3050 accepts an event input pulse to
external incidents requiring precise
y. For
s an
connector power port on the rear of the
1 PPS
s available from the SF-3050 at an output
per second. This pulse can be used for a
The SF-
synchronize
GNSS time tagging, such as aerial photograph
example, the action of a camera’s shutter create
input pulse to the Event port. The SF-3050M outputs
position and time information relative to each event
received.
The Event is input on Pin 3 of the 9-pin male
Positronic
sensor (refer to Table 7).
Specifications:
 Selectable I put Volta
n ge, 5V or 12V
m pulse width, 100nS
 Rising or Falling edge Synchronizatio
 Minimu
n
Detailed specifications of the Event I
cable wiring, and configuration may b

nput,
e found
in Appendix D of this User Guide.
A pulse i
rate of once