Rtk fixed tolerance – NavCom LAND-PAK Rev.F User Manual
Page 102
Advertising
LAND-PAK™ User Guide – Rev. F
5-102
RTK Fixed Tolerance
Perform these steps to set the RTK Fixed tolerance
parameters:
1. Log on to FieldGenius and select a project or
create a new one.
2. On the Instrument Selection dialog box (refer to
Figure 39), select GNSS Rover.
3. Click Edit.
4. On the GNSSS Profile dialog box (refer to
5. Figure 57), click Tolerance Setting [RTK Fixed].
6. On the Tolerance 3 dialog box (refer to Figure
58), set the parameters and click OK.
The recommended setting for a long
baseline is:
Position (H): 3cm
Position (V): 6cm
When setting the above parameters,
keep the selection RTK Fixed on the
Solution drop-down list box.
Advertising