NavCom LAND-PAK Rev.F - Manual (Page 52)

LAND-PAK™ User Guide – Rev. F
3-50
A 3.7V 5200mAh Lithium-Ion battery pack powers the
Nautiz X8. It can provide approximately 6 hours of
operating time on a full charge (depending on power
management and use).
Before changing the battery pack, press
the Power key to put the terminal in
Suspend Mode to suspend all
operations. ALWAYS put the terminal in
Suspend Mode prior to changing the
battery.
Charge the battery pack in the Nautiz X8
until it is fully charged before first use.
Installing the Nautiz X8 Battery
1. Remove the battery chamber door by moving the
door lock to the left and lifting the door through
the slots on the sides.
2. Insert the battery into the battery well with the
connectors facing the top.
3. Replace the battery door by inserting the bottom
first, then push the top until the lock is secure.
The battery door must be replaced prior
to booting up the unit.
Charging the Battery
1. Attach the appropriate plug adapter to the plug of
the power cable.
2. Insert the plug into the appropriate power source.
3. Plug the power cable into the USB Jack on the
side end of the terminal.
4. Allow five hours to charge the battery to full
capacity.