NavCom LAND-PAK Rev.F - Manual (Page 104)

LAND-PAK™ User Guide – Rev. F
5-104
Set the Active Tolerance
To set a tolerance as the active tolerance, perform
these steps:
1. Open FieldGenius and select a project or create a
new one.
2. On the Instrument Selection dialog (refer to
Figure 39), select GNSS Rover.
3. Click Edit.
4. On the GNSS Profile dialog (refer to Figure 59),
click Active Tolerance [StarFire].
5. On the Select Tolerance dialog (refer to Figure
60), select an active tolerance, and then click OK
on the GNSS Profile dialog box.
Figure 59: GNSS Profile/Active Tolerance [StarFire]